The installation process of the Extended DMS has been redesigned. If you are looking for information in relation to the old DMS installation process. please follow the pages marked "DEPRECATED" in the hierarchy. Some information in these pages may be useful in case of issues with the setup, however, the following process should be complete to get your DMS installation up and running smoothly

1. To start with, please download our pre-configured .ova image for VMware ESXI 5.5+ environments (also available as .vmdk image). For Hyper-V environments, please download our pre-configured .vhdx image. For Xen Server, please download or pre-configured Xen-compatible image for importing into Xen. Similar templates for other virtualization platforms may be available on request.

2. Create a VM using the image, start up and perform the necessary network base settings (default is DHCP which is generally unsuitable for a DMS server appliance). Set your network settings by running "nmtui". It is suggested that you set your network to a static IP. Remember to also set addresses of your internal DNS server. You can find some help, e.g. here.

   After you set your network settings as required, please restart the network service:

   systemctl restart network.service

   After that, reboot the host. Your network is now ready to use with the parameters you set.

3. Assign a FQDN to the static IP of your DMS server in your DNS server.

4. Make sure that /etc/timezone file exists and locale is set appropriately (eg. Europe/Berlin)
5. for setting your timezone on the OVA (CentOS 7) use timedatectl set-timezone your_time_zone and make sure that your_time_zone is valid.

6. Create a ssh key using

   ssh-keygen -t rsa

   which creates a unique pair of public/private keys for your environment. Use default values, if possible. If you have to name your key-file differently than "id_rsa", please see below.

7. Send the "id_rsa.pub" file from ~/.ssh/ to Patrix and/or PI to set up authenticated access to your client specific repository holding your setup configuration.

8. From thereon, you should be able to continue with our auto-deploy technology: Click here to continue.

Note: If you are using the DMS with a storage mount point to hold your repository data, to ensure proper functioning after a host reboot, you should modify the docker configuration so as to make sure docker is only started once the storage out point has become available to the host. Please check here for further information.

Pre-configured centos .ova configuration

CentOS 7 installed in a 100GB partition with the following components/settings:

• Kernel 3.10
• git with 2.10.1
• Docker 17.05
• User "dms" with sudo rights and PI SSH keys allowed to login
• NTP Enabled, pre-set locale/timezone Europe/Berlin (CET)
• Pre-installed auto-deploy scripts

The locale/timezone settings can be changed as needed, the auto-deployed scripts can be updated by pulling from the git repositories.

Make git use different key file than default "id_rsa"

This will not be required under normal circumstances - it is merely given here for special situations and when advised by Patrix or Practice Insight.

If you had to use a different name for your key-file than the default "id_rsa", you can make git use this key file for accessing the client specific repository as follows:

cd into .ssh/ directory and un create file "config" file with following contents:

Host edmssupport.pace-ip.com
IdentityFile ~/.ssh/<private_key_file_name>

<private_key_file_name> should be the key file that you produced using ssh-keygen or copied into the system.

Finally set the security settings on the relevant files as follows:

chmod 600 .ssh/<private_key_file_name> && chmod 600 .ssh/config

replace <private_key_file_name> accordingly.